Atlas Putty Products Company Page 1 of 2 Vinyl Spackling Compound Issue Date: 7/05
HMIS: 1,0,0 (H,F,R)
Section I-Chemical Product/Company Identification
Atlas Putty Products Company Phone: 708-429-5858
8351 West 185th Street Fax: 708-429-4280
Tinley Park IL 60477 Emergency Phone Number: 708-429-5858
Section II-Composition/Information on Ingredients
Common Name C.A.S. No. Wt. % PEL TLV units
Aqueous Polymer Solution [Nonhazardous] 11 max NA NA
Calcium Carbonate** 1317-65-3 75 max Total Dust 15 10 mg/m3
Respirable 5 mg/m3
Water 7732-18-5 16 max Nonhazardous
Ethoxylated Nonylphenol [mixture] 0.1 max Not Established
Unlisted ingredients are not considered hazardous by the Federal Hazard Communication Standard 29 CFR 1910.1200
**Inhalation of particulates unlikely due to product’s viscous nature
Section III- Physical/Chemical Characteristics
Boiling point: Variable Appearance & Odor: White Paste/Mild latex
Vapor Pressure: >1 (mm Hg) Water Solubility: Partial
Vapor Density (Air =1): <1 Specific Gravity: 1.5-1.7 (water =1)
Evaporation Rate (Water =1): 1 Percent Volatile 20 % maximum
pH 8.0-9.0
Section IV- Fire & Explosion Hazard Data
Flash Point: Noncombustible Flammable Limits: LEL: NA UEL: NA
Extinguishing Media: Use extinguishing media appropriate for surrounding fire.
Special fire fighting procedures: Remain upwind. Avoid breathing smoke.
Unusual Fire/Explosion Hazards: Material can splatter above 100C / 212F.
Section V- Reactivity Data
Stability: Stable (Avoid temperatures above 177C/350F)
Incompatibility (Materials to avoid): halogens, oxidizing agents, molten sulfur
Hazardous Polymerization: Will not occur.
Reactivity with common materials: Non reactive when product is used in accordance with intended use.
Section VI- Health Hazard Data
Route(s) of Entry: Inhalation: Not acutely toxic by inhalation.
Skin: Non irritating if intact unbroken skin is contacted
Ingestion: Do not take internally. May cause gastrointestinal distress.
Eye Contact: May cause slight eye irritation. Avoid eye contact.
Emergency and First Aid procedures: Skin contact: Wash affected area with soap and water.
Inhalation: Remove patient to fresh air.
Ingestion: Do not induce vomiting. Consult physician immediately.
Eye contact: Flush eyes with water for 15 minutes.
Consult physician if any irritation persists.
Atlas Putty Products Company Page 2 of 2
Vinyl Spackling Compound Issue Date: 7/05
Section VII- Precautions for Safe Handling and Use
Avoid eye contact. Use in well ventilated area. Wash contacted skin as soon as possible after exposure.
Spill/Release/Disposal Information: Scoop up, place dried product into waste container for solid waste disposal.
Dispose of in accordance with Federal, State and local guidelines for handling
nonhazardous waste.
Storage: Keep containers tightly closed when not in use. Store between 40 F and 90 F, away from foodstuffs or drinking water.
Section VIII- Engineering Controls and Personal Protective Measures
Respiratory Protection: Wear NIOSH approved respiratory protection when working in enclosed areas.
Ventilation: Apply product using adequate ventilation.
Protective Gloves: Plastic or rubber gloves may be used to avoid skin contact.
Eye Protection: Eye protection in the form of protective glasses or goggles is recommended if product contact is likely.
Other protective
clothing or equipment: eyewash facility accessibility
General Work
Hygiene Practices: Do not eat, drink or smoke when using this product. Wash hands and contacted
areas with soap and water before taking breaks and after completing work.
Section IX- Hazard Classification
This product is considered nonhazardous under the OSHA Hazard Communication Standard (29CFR 1910.1200)
This product is not a ‘controlled product’ under the Canadian Workplace Hazardous Materials Information System (WHMIS).
All ingredients within the product are listed on the Canadian Domestic Substances List where applicable.
US DOT considers the product NON REGULATED.
This product does not contain a chemical listed in Section 313 at or above de minimis concentrations.
Release of this material to air, land or water is not reportable to the National Response Center under CERCLA or SARA.
Discarded material is classified as a RCRA nonhazardous waste.
All components of this product are in compliance with the inventory listing requirements of the U.S. Toxic Substances Control Act (TSCA) Chemical Substance Inventory.
This product MAY contain a chemical (formaldehyde, CAS # 50-0-0, less than 1 ppm) known to the state of California to cause cancer.
The above information is believed to be correct as of the date hereof. However, no warranty of merchantability, fitness for any use, or any other warranty is expressed or implied regarding the accuracy of this data, the results to be obtained from the use of the material, or the hazards connected with such use.